3ware 9650SE-2LP

• 3Ware 3Gb/s SATA II RAID (drives supported).
• Features two internal ports and RAID levels 0, 1, Single Disk, and JBOD.
• Performance driven by a PCI Express host interface, StorSwitch™ architecture and SATA II features.

• 8th-generation StorSwitch™ non-blocking switched architecture
• On-board I/O RISC processor and RAID offload provides true hardware RAID- SCSI device driver model to take advantage of the benefits of SCSI using inexpensive SATA drives
• Bootable array support for greater fault tolerance (not available with MAC drivers)
• Variable stripe size for performance tuning by application
• 64-bit LBA support
• ATA pass-through mode support
• Up to 512MB DDR2 533 memory with ECC protection
• 32 pooled DMA channels
• Complete configuration management suite
• - 3ware BIOS Manager 2 (3BM2) – easy to use BIOS configuration tool
• - 3ware Disk Manager 2 (3DM®2) – browser-based management tool
• - Command Line Interface (CLI) – scriptable configuration tool
• SNMP support
• SMTP support for email/pager notification
• ATA/6 and Out of band (OOB) staggered drive spin-up support
• Auto carving allows LUNs > 2TB to be divided into multiple units for legacy operating systems limited to 2TB max per LUN
• Multiple logical unit sizes and RAID levels on one card
• Multiple card support within a system for large storage requirements
• Hot-swap and hot-spare support for data availability
• Dynamic sector repair for robust data protection
• S.M.A.R.T. disk drive monitoring for reliability
• Emergency Flash Recovery protects against failed firmware upgrade
• Drive activity LED support
• Online Capacity Expansion and RAID Level Migration
• Enhanced data protection with write journaling for non-redundant arrays and accidental drive removal
• Drive insertion and removal notification
• Array/Drive Status and drive identification LED support (requires 3ware Chassis Control Unit-enabled backplane)